The scope of work for the
consultant is as given below.
·
Review of the
project preparation request for a demonstration project on development and
evaluation of spray foam polyols systems for buildings using
Hydrofluoroolefins (HFOs) as blowing agent submitted to the 74th Meeting of
the Executive Committee along with the comments of the Secretariat that
relating to key aspects to be covered in the demonstration project. The
status of implementation of existing systems house project under HPMP Stage-I
and its main outputs should also be reviewed by the consultant;
·
Study of polyol
formulations with HFO-1233zd(E) as blowing agent in terms of key
thermo-physical and structural properties and costs of formulations to spray
foam users;
·
Develop project
costs for identified enterprises using these formulations for spray foam
applications for conversion from HCFC-141b to the HFO based formulation;
·
Assist Ozone Cell in
getting confirmation from the downstream enterprises for participating in
this project for phasing-out HCFC-141b and converting their spray foam
facilities to low Global Warming Potential as blowing agent, as per Ex-Com
requirements;
·
Develop a field
trial plan for use of HFO based formulations both in new buildings and
existing buildings and training plan for downstream enterprises using spray
foam;
·
Hold consultations
with relevant industry stakeholders and Ozone office on the feasible options
and obtain stakeholder agreement to the proposed technology options;
·
Prepare a project
report for the conversion project to HFO based formulation in spray foam
applications including costs for conversion and implementation process for
the project;
·
Assist UNDP and
Ozone cell in addressing comments of the MLF Secretariat on the project proposal
submitted for consideration at the meeting of the Ex-Com.
Deliverables:
·
Project proposal
outline and methodology;
·
Draft project
proposal;
·
Final project
proposal;
·
Facilitation in
approval of the project proposal by the Ex-Com.
|
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.